cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
553
Views
0
Helpful
4
Replies
Highlighted
Frequent Contributor

E1 Config - nim-1ce1t1-pri

Hi CSC,

 

For configuration of the above module for data, is there a generic config that would be applied across the board or are there certain parameters that need to be supplied by the actual circuit provider? Not something I have configured previously. Is this the correct configuration guide? 

 

https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/NIM/software/configuration/guide/4gen-t1-e1-nim-guide.html#task_1074539

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Expert

Hello,

 

typically, the only settings that might be different depending on the provider you have and/or the region you are in are framing and linecoding. When the line is provisioned, the ISP usually tells you which values you need to configure...

View solution in original post

4 REPLIES 4
Highlighted
VIP Expert

Hello,

 

typically, the only settings that might be different depending on the provider you have and/or the region you are in are framing and linecoding. When the line is provisioned, the ISP usually tells you which values you need to configure...

View solution in original post

Highlighted

Thanks as always Georg,
is that cisco url the correct place for going through the configuration? Or is there another guide you would recommend?
Highlighted

Hello,

 

the guide is very comprehensive and covers all settings, so that's probably all you need. If you run into any problems, post here again...

Highlighted

Hi Georg, quick addition to this - does this nim default to a particular speed, e.g if the link provided is a 2mbps, I'm wondering if shaping would be required, or if there is a part of the e1 config that hard codes the speed to say 2Mbps