07-07-2009 08:04 AM - edited 03-04-2019 05:21 AM
I'm getting the following errors logged on one my 2811 routers with dual ADSL cards. The ATM0/1/0 status is also sat at initializing. Anyone any idea what the problem might be.
HWIC_ADSL_BRI-7-NETSPURIOUSEVENT: HWIC_ADSL_BRI 1: Spurious network interrupt 0 happened, mask 3FF
07-07-2009 12:29 PM
Typical bug symptom, try upgrading IOS but if it happens again you have to contact the TAC and ask to reproduce.
09-20-2012 02:07 AM
Hi! I also getting the similar error message as in below. I saw only one router. I don't see such errors in many other routers with the same IOS (c1900-universalk9-mz.SPA.152-1.T1).
If you have any update/ feedback, please help to share.
%HWIC_HDLC_BRI-7-NETSPURIOUSEVENT: HWIC_HDLC_BRI 1: Spurious network interrupt 0 happened, mask 700
Thanks,
Ye
09-20-2012 03:02 AM
Hi,
It could be due to:
1. Card HW failure.
2. Loop length issue on the HWIC-1B-U cards:
CSCtl22335 %HWIC_HDLC_BRI-7-NETSPURIOUSEVENT: HWIC_HDLC_BRI 1:Spurious network
It was fixed with new HW revision of this cards).
3. pulsing signal on the link.
Kidn Regards,
Ivan Shirshin
09-20-2012 06:59 PM
Hi Ivan,
Thanks a lot for your prompt response. At present, the bug is under review and not shown.
Saved it to my watch list.
Regards,
Ye
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide