05-12-2006 06:16 PM
Got a ' spared ' 3825 off our recently departed marketing guy.
Upon power apply, I can see the fans run but no Sys, Power LED on the pannel.
No console output .
No flash nor memory installed but I know the system should boot with some kind of error and flashing green.
Is there a default jumpers to reset if the system hung up ?
Or this baby gone with the l00pback interface ?
No smartnet for this baby.
Thanks for answering,
Loc P
05-14-2006 08:40 PM
Hi
Are you sure about the installation of both Flash/DRAM on the router ??
Also did u try changing the baudrate on the console and checked up ??
regds
05-15-2006 05:33 AM
Until I can get it to boot, no, not really !
But I did try methodolotically, 1-b-1 all the baud rates. What discourage is LED not even light up.
Anyone have a snapshoot of the PS ?
Regards,
Loc
10-14-2006 03:05 PM
i think you have a BAD motherboard. Raise an RMA
Narayan
02-26-2007 05:26 AM
Have encountered similar issue with 6509 switch and 7513 router, after I sent them to site. I have to unplug and replug the modules (sup and rsp) before it kicked in, seems like lost contact during transport :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide