I have given the assignment to rack mount a bunch--17 x Cat6509s preloaded with blades. Can the above be accomplished by one person within a work week? I am not familiar with Cat6509s.Thanks.
Hi,I've just brought a cisco Cat 5505 and it is not booting. The unit has the following cards installed:Slot 1: BlankSlot 2: WS-5530-E3Slot 3: WS-X5302Slot 4: WS-X5224Slot 5: WS-X5224I have tried moving all cards up one slot so the supervisor engine ...
I am planning to install an I/O (C7200-I/O-2FE/E)controller in 7206VXR, it doesnt have any I/O controller as its running with NPE-G1, do i need to bring down the router to install the controller or does it support OIR for controllers too.
I'm running a basic Sup720 and want to purchase a mix of Gig copper linecards for the same chassis. I would like to use the 6748-RJ45 with a DFC daughter card. So far so good, if I add a 6148-RJ45, does that affect the distributed function of the 6...
hi all...I am implementing dual 6513's with slots 9-13 loaded with 48 port 10/100/1000 cards. I came to the realization that if I manage my cables equally from the left and right (24 in from each side) that i would not be able to easily hot swap out ...
I'm trying to find a credible source for link loss budget in a 4Gb short wave fiber channel. I'm looking for the total budget. I can find lots of data on insertion loss over specific components and attenuation over any myriad types of fiber. However,...
Hi,I would like to monitor the status of various serverfarms, realservers and VIPs on our ACEs with regular SNMP polling.I do not find appropriate SNMP OIDs for the status of rservers and serverfarms.I looked through some MIBS: CISCO-SLB-MIB CISCO-SL...
RTRA(eigrp)-RTRB(a0)-RTRC(a0+a66)-RTRD(a66)||RTR EAll the routers are conncected using serial links.RTR A is running Eigrp and RTRB, RTR C and RTR D are running ospf.10.0.0.0 /8 network is used on RTR A and RTR E whereas 172.0.0.0 /8 is used on the r...
HiI'm currently engaged in a IT definition project and I have to define 4 racks or cabinets (42U) for 2 core switches (6509E) and 2 datacenter switches (6513). Another network equipments will be deployed in these racks (firewalls, VPN concentrators, ...
we are in a process of designing a New DC having reseliency, redundancy, security, FT,scalability & future growth.It there any best practice to follow. We are planning to use 6500 with Service modules. Can anyone suggest the various blocks DC block, ...
Hi,Can anybody tell me what is the difference b/w 3560 and 3750 switches. Secondly I need to have 10Gig ports on 6509 switch to support my servers. I have seen 10Gig modules in 6500 but I need 10Gig modules that support normal Cat6 Cables.Need your h...
My two 6500 run in redundancy, with vlans balanced between them. One cat has the following cpu load:RJ6509_1#sh proc cpuCPU utilization for five seconds: 36%/32%; one minute: 47%; five minutes: 42% PID Runtime(ms) Invoked uSecs 5Sec 1Min ...