Server Networking

I am trying to configure our Nexus 2K's for our ASA 5520 management ports.  We have 2 bundles (4 mgmt0 ports) and when i connect them to the 2K's the interfaces continue to show disconnected.  I have attempted to put the ASA MGMT0 interface directly ...

Hi Folks,Is it possible to determine what the subject field of a callhome message generated by a Nexus 5548 (using the command 'callhome test inventory') will be?Thanks,Darragh

We are trying to activate a link between a Cisco 2851 and a AS400 (iSeries)snasw cpname PRUEBA.SNASWsnasw port HPRLOOP hpr-ip Loopback0snasw pdlog informationsnasw dlctrace format analyzersnasw event dlcinterface Loopback0 ip address 192.168.104.31 2...

Hello,I have a question regarding N5K/N7K devices CPU monitoring:Let's say I see CPU spikes in "show proc cpu hist" command.Is there any way I can verify what process caused the CPU spikes?I know that I can see that using "show proc cpu" or "show pro...

Hey all,I posted the below in VMware's forum yesterday, now I'm cross posting here for advise. I'd like to add after a day of research though -There is a LOT of advice on the Internet around this problem, generally suggesting the CONTROL VLAN isn't t...

Using the above setup can i use 4 disks, striping them togther in sets of two and then using one to mirror the orther. So I have Raid 0 and 1. I have only 2 disks at the moment but I will buy two more if I can do it.Basicly I want the fasted mirrored...

Hi,Our customer needs two Nexus (5548 + 5020) all with FCoE. What licenses do I need for each of them, if any?I am a bit confused:For 5020 there are:N5020-SSK9Nexus 5020 Storage Protocols Services   License1$24,000.00N5020-FNPV-SSK9FCoE NPV Lic for N...

New to Nexus in the Datacenter and looking for real life experiences and / or suggestions.Environment;- Dual SUP720 (8 port 10G blade in each) 6500 Distribution Layer - no VSS- 2 N5K 5548- 4 N2K 2232Design;- 2 Uplink from each N5K, 1 to each 6500 con...

Hi,I have a Catalyst 3560 and when trying to assign IPs to a port (using telnet to the switch's main IP) I keep getting an error.Here is the commands as s I am trying to enter them and you can see the error I have highlighted in red below.SC-153>enab...

I have a problem whit VPC configured on nexus 7000, when the peer-link connection goes down the vpc goes down too and the status of the interface show vpc peer-link is down