Server Networking

Hi,I have got a trouble with IP assignment for colo servers. Each server assigned public IP. However, I lost some public IPs belong to subnet due to my customer use more public IP for VPS service.It's not easy to find out who used them consciously. I...

I know the Nexus is still very new but does anyone have any feed back?

Hi Please help me out with problems we are faceing we have a Microsoft Exchange server 2003 with Microsoft clustering service that with teaming configured Active/Active it functions properly the server is IBM 3650 server with broadcom Nic with Teami...

HiOne of our server guys has reported a problem with port teaming his Win 2003 Dell servers (running MS Exchange). He has set them up with an active port attached to 6509-A and a standby port attached to 6509-B. The servers have Broadcom NICs. At tim...

I have two 6509 and two CSM module.serverbank-I is conected with the 6509-1 and second serverbank-II is connected to 6509-2, and 6509-1 and 6509-2 are connected to each other via CWDM link,I can access all the real servers from both switches,My prob...

The senerio contains a PIX 515 E firewall,4507R Chassis switch and a CSS 11503. The servers in inside zone of the PIX is load balanced using a vip with default route specified in the CSS is the inside zone interface IP of the PIX Now I would...

Hi,we are doing some staging activities, Both 4492 Gss are connected in the same vlan ,one configured as primary and other standby, both are communicating each other, when we down the primary GSS ,standby is not becoming active .How can we achieve th...

Hi all,i have two GSS 4490 series...one is configured as GGSM Pri and the other as GSSM sec.However when the pri goes down(simulated by taking down the link) the sec is not taking over as the primary... the sec gss status still shows as standby.Is th...

Is Infiniband a parallel technology to Ethernet to use with IP or is it a SAN interconnect for storage? Or can it be used in both scenarios?The last time I checked there was 10 Gbps Ethernet available over copper. What's the maximum bandwidth availab...

I'm looking to use a RPS 2300 to act as a redundant power supply for some 2950 switches in my data center. I figured that they would be able to keep my 4 switches up and running in the event that power was lost to the switches. As long as I have my...

I have a basic CSM setup where 2 servers are load balanced accross a CSM. How would I disable anything other than established connections for going out of the servers through the CSM's? The servers are externally managed where incoming loadbalanced (...

Dear alli have datacenter with web server runs IISits about 2000 session same time on web server and this is main reason that my IIS server stops working while the server performance is acceptabeldoes cisco has any device for limiting session in same...

I think I posted this onto the wrong Forum. Anyone able to advise here?SteveK.Posted by: stevek1 - Network Administrator, Dept Natural Resources and Mines Apr 18, 2008, 12:04am PSTHi Folks, I need to provide internal devices with active-active acces...