Server Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

when I tried to install new UCS B200M4 the discovery of the blades failed as shown in the attached imagesbut when inserting B200M3 it discovered automatically in the chassis as in fig. error 3

Amr Hafez by Level 1
  • 2437 Views
  • 3 replies
  • 0 Helpful votes

hi everyone,I am trying to decode sensor output of Cisco C220 M3.I have attached the output to this post. I have not been able to find a guide or specification to describe all of these sensors. Where would I be able to find a specification to decode ...

We implemented 6 blades B200-M3, 2 FI 6248UP, SAN SW:brocade and EMC VNX 5200 storage ESXi 5.5 free edition installed to the blades and installed VMs when we tested the HA between 2 FI, the VMs were pingable but some VMs dropped 1 ping and other drop...

Amr Hafez by Level 1
  • 280 Views
  • 2 replies
  • 0 Helpful votes

When we tested the HA between 2-FI 6248UP and we used the ping operation to insure that the management IPs are pingable then after we reboot the primary FI, the subordinate FI management IP was pingable but the cluster IP  took around 10-15 min to re...

Amr Hafez by Level 1
  • 209 Views
  • 1 replies
  • 0 Helpful votes

Has anyone else ran into this issue with deploying the VSM using VSUM through the vSphere Web Client? The wizard complains that the VSM requires "a valid username must have more than 0 characters" and I am unable to click "Finish" to continue with th...

                   I have a new UCS system that was installed by my engineering group. I am trying to get SCOM 2012 SP1 to see it. I installed the Cisco UCS Managment Pack 2.6 into SCOM without any issue. I then try and configure the monitor wizard a...

rdanjou47 by Level 1
  • 670 Views
  • 2 replies
  • 0 Helpful votes

I have inherited a Cisco UCS C220 M3 in the lab at work and am trying to get it working.  I'm logged in to CIMC but when I launch the KVM my browser just downloads a file:viewer.jnlp(10.10.10.1@0@141x7x5x7x2x1) Following advice in other threads I hav...

I am unable to connect to a remote host from my unix machine and get the following message:ssh_exchange_identification: connection closed by remote host1- I added my ssh keys again to my ssh directory2- compared the .pub key on my ssh directory to th...

bellah123 by Level 1
  • 573 Views
  • 0 replies
  • 0 Helpful votes

Good Afternoon,   I am starting to work with the Nexus 1000V switch, however I am running into a little bump and would like some assistance if possible. I have a dell R720 with:2x Broadcom NetXtreme 1G2xIntel Ethernet 10G 2P X540-T I am included the ...