Unable to connect between Router and PC with crossover cable in Cisco
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 09:26 PM - edited 01-19-2022 07:48 PM
I just started my CCNA course. I tried to connect the router to the PC with a crossover cable, but it always shows that the MyIndigoCard is down. Any configuration I might have missed?
- Labels:
-
Smart Call Home
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2022 02:52 AM
what device is this ? what is the configuration on that port ? is the admin state up ?
post show interface gx/x to understand the issue, check the cable (if you have straight cat 5/6 cable or new cross cable ?)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2022 08:20 AM
Is IP address assigned and no shutdown issued? Unlike in switch, router ports/interfaces must be brought up with no shut command and IP address assigned to that interface.
Regards, ML
**Please Rate All Helpful Responses **
