Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I know I can deploy few PSC nodes from PSC 12.0 OVF for redundancy. Redundant deployments on Windows (not OVF) differentiates nodes to roles - controller, PSC nodes, service link node. Does the OVF deployment also diferentiate nodes to separate r...
my wife can access the work ERP system fine. But her Windows mapped drives do not work - i.e., using Windows Explorer to browse "G:" or "\\SERVER" either hangs, or transfer files at 1-2 Kbps.From her laptop, network speed tests report a consistent 40...
Check this out, this might help : https://www.cisco.com/c/en/us/training-events/training-certifications/certifications/expert/ccie-enterprise-infrastructure.html
@AJ Cruz wrote:UPDATEThis appears to have nothing to do with ENCS. I used the same FTDv image directly in my ESXi environment so that the only difference was the VM/version of FTDv and I get the same behavior. Closing this and re-posting in the firep...
@Mark Elsen wrote: - FYI : https://helpdeskgeek.com/how-to/restrict-access-cisco-switch-based-ip-address/Pasco ConnectThis was the exact problem I was looking for and the answer worked great. Thanks a lot.
@coalbl4ck wrote: Kroger eScheduleHi, i am new to CISCO equipment.In my setup i have a CBS350-8T-E-2G connected to an OPNsense firewall.Now, the switch sends requests to '2.17.186.22:80'.According to ipinfo.io this IP belongs to Akami Technologies, w...
@Rob Ingram wrote: njmcdirect@Asfandyar70754for the WSA, I have previously just used M1 for dedicated mgmt and P1 for proxy, these interfaces are in separate VLANs, with a different routing table. The number of interfaces that you choose to connect ...
