05-11-2018 08:49 AM - edited 03-12-2019 07:47 AM
We have a new CSPC appliance we are using to run scheduled collection and uploads to the SNTC portal. We deleted out the inventory in the portal, verified it was cleared, created a new discovery/upload job and saw it completed successfully. The CSPC show 7 devices, but when we go to the portal, we can see over hundreds of devices. When you drill down into it, the 7 new devices are there, but its still showing all the older data that was deleted. We tried changing the view to 'Latest View' under the report settings as well but the same result.
Instead of messing with that inventory, we now just re-registered the CSPC to a new inventory and tried to upload the data again, but now it looks like its stuck (been running about 1 hour, usually takes 5 minutes). Is this the best way to create a new, fresh inventory so we dont see old data in there that was manually uploaded in the past? Also how long should we wait for the upload?
Thanks!
05-11-2018 10:23 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide