We have just upgraded to ver 2.1.2e fabric manager software and it appears that FM is not recognising the difference between hosts and storage.Is this a bug or do i need to check a box somewhere?Never had to before so....!Thanks Jason
. I am running fcip on and I get a compression ratio of about 1.7, how can I improve this?The link is a 6meg link with a latency of 3-5ms under load.There are 3 fcip tunnels between 3 9509s and one 9216 on the far side, we are using EMC2 mirrorview
hitrying to find in FM but didnt found, my customer concerns is to migrate 1000 zones from Vsan 1 to Vsan 400 so it is possible without rebuilding all zoning informations in vsa400 ?thanks in advanceJYP
Does anyone know how to retrieve the last time each port on a mds 9500 series director was issued a shutdown command?I have the problem listed in the release notes for san-os 1.3(3c) under CSCee89946 where once the uptime for a port reaches 248 days ...
I am having issues authentication with network-admin privileges via TACACS on the MDS. I defined the custom av attribute in the tacacs settings on acs as follows:cisco-av-pair=shell:roles="network-admin"For some reason it doesn't seem like the AV pa...
Hi,I have been reading up about the pro's & con's of using port wwn over node wwn. From what I have read so far, I understand that port wwn zoning is more secure but more hassle when/if you change ports. Node wwn seems to be easier to manage but is ...
The Cisco 9216i switch's mgmt interface is on a private LAN that does not have an SMTP server. Is it possible to route outbound email through a gigE interface which is also an FCIP ISL?Has anyone had success at implementing Call home without a SMTP ...
We have recently upgraded our 9500 sw to 2.1.2b and since this, we have been receiving ambiguous snmp traps.Is there an update i can load into our openview server that will correctly interpret these messages.Grateful for any helpJason
SERVER F - MDS1 TE - TE MDS2 - FL DISK1/DISK2(I'm only talking about SERVER to DISK traffic)Let's say we want to prioritize SERVER-DISK1 traffic over SERVER-DISK2 traffic.QoS is possible, we simply configure QoS on MDS1 and put SERVER-DISK1 traffic i...
I'd like to understand where the IP control & forwarding planes resides within the Cisco MDS 9000 Family 14/2-port Multiprotocol Services Module. Due to the low number of GE interfaces per card and for resilience, if FC to IP conversion takes place o...
