"default interface" equivalent for SG300/500 switches?

[rcoote5902_2]

Can anyone tell me if there is an equivalent CLI command to reset an interface configuration to default?

In IOS it is "default interface <interface>" which removes all configuration from that switch port. I don't seem to be able to find the same in the SG series CLI.

Thanks,

Rob

[chrebert]

Hello Rob,

There isn't an equivalent command on the SG series switches, but I will be bringing it up as a feature request, because it would be quite useful.

Until then the only way to reset a port would be to use all of the no versions of the commands, which I know can be a bit of a pain.

Thank you for choosing Cisco,

Christopher Ebert - Advanced Network Support Engineer

Cisco Small Business Support Center

*please rate helpful posts*

[Michal Bruncko]

hello please had you luck with that feature request? was it accepted by management? We are missing such feature on SG switches as well. thanks!

[Yiu Kay Lee]

Hello,

We'll check with the switch product team.

Thanks.

Yiu Kay Lee

Concentrix at Cisco

.:|:.:|:. CISCO | Yiu Kay Lee | Network Engineer | SMB Presales | yiulee@cisco.com

[jodson.martins]

I have this difficulty in performing the same procedure.

Default ports

Does cisco have any feedback on this topic?

CISCO SERIE GS300

DON'T HAVE -> (DEFAULT) INTERFACE GEXX

att,
JODSON MARTINS

[Alan Daniel Chavira Rodriguez]

any news?

hard to believe that default is missing

BR

[Yiu Kay Lee]

Hello,

Was informed that default interface CLI command feature is not in the road-map.

Thanks.

Yiu Kay Lee

Concentrix at Cisco

.:|:.:|:. CISCO | Yiu Kay Lee | Network Engineer | SMB Presales | yiulee@cisco.com

[waltreed]

Here we are 3 years later. Can we get it on the roadmap? The No commands unfortunately don't clear all the garbage automatically created.

[Paolo Moserle]

Please add this command !

[mozga]

When to expect this feature? :(

[rajp]

use this command : no macro auto smartport