I have a couple of SG250X -24 port wit firmware 126.96.36.199, after a while the web interface is not more reachable through https protocol, I need to enable the http server via cli.
I upgraded the firmware from 188.8.131.52 version to try to resolve this problem, did any else resolve the same problem?
Solved! Go to Solution.
Can you post screenshot to look, also I would suggest to open a SMB tac case to investigate for you.
If you still looking to resolve by your own.
take the config backup from the device.
reset the device to factory
upgrade to latest firmware (in case required, )
restore the config and testit.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: