3750 rommon xmodem command unknown

[neil]

I am trying to xmodem an image to flash but when I enter the command in rommon to xmodem. I receive:

switch: xmodem

Unknown cmd: xmodem

Not sure why I am getting this. It has always worked in the past.

[Collin Clark]

It's been a while since I had to do that, but don't you invoke XMODEM through the terminal emulator (ie SecureCRT)?

[neil]

I got it

I did copy xmodem[filename] flash:[filename]

That seemed to work

[Edison Ortiz]

The routers using the command xmodem while the switches use the command copy xmodem..

[glen.grant]

I can also advise you to set the baud rate on the switch and the terminal emulator to 115200 , this will take a download of code of this size from like 2 hours down to like 15 minutes .