08-27-2021 07:55 AM
Hi,
We have a cisco C9200-24T device we discovered when assigning these specific ports GigabitEthernet1/1/1-4 to a vlan they will not show up in the vlan database for some reason. All ports are configured for access mode and other ports were assigned without any issues. I have attached a file with the vlan, port and interface information for review. Any assistance would be greatly appreciated.
Thanks,
08-27-2021 09:39 AM
- Could depend on connect-status , anyway can they (allow)-traffic according to the assigned vlan ?
M.
08-27-2021 10:39 AM
Hi,
The vlan is associated to the DMZ, so are you saying a ACL will need to be created to allow traffic for the vlan?
Thanks,
08-27-2021 10:50 AM
I believe @marce1000 is correct on the connection status. I am pretty sure the interface will not show up in the VLAN database if the status is down/down which is what it looks like from your output for interfaces GigabitEthernet 1/1/1-4. There must be an active connection for it to show "active" in the VLAN database. TO test plug a device into one of those ports to bring it up and see if it adds it to the vlan database as active
08-27-2021 06:12 PM
@Quintin.Mayo wrote:
Version 16.11.1
I've seen enough just by looking at the first line of the attached file.
16.11.1 -- There's the culprit right there.
08-28-2021 02:33 AM
Hello
If the vlan isnt the the vtp database then:
1-youve tried to create the vlan on the switch itself and that switch vtp is in vtp mode of client
2- youve created the vlan on a differing switch and the related siwtch is in a vtp mode of transparent or differng vtp domain or vtp password(if applicable) doesnt have parity
show vtp status
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide