Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hello, I am quite puzzled with the issue I am having. In my test, I had route-leaking setup. Saved the configurations and turned off the router. Next time I boot up the routers, my route-leaking isn't working.  Problem:1) Computer VRF cannot ping any...

Shawnw4401 by Level 1
  • 3083 Views
  • 23 replies
  • 0 Helpful votes

Resolved! telnet password

Hello, Please tell me, if we configure line vty password then it is not secure. for example. s1(config)# line vty 0 15 s1(config-line)# password 12345 s1(config-line)# login local s1(config-line)# end it is not secure. if we create a user and then en...

nnn_sss22 by Level 1
  • 5883 Views
  • 3 replies
  • 0 Helpful votes

Hello Please give me answers 1) when we configure telnet and we put this command s1(config)#line vty 0 15 what is mean by line? 2) i have 2 users.  first admin and second assistant my requirement is when admin come through telnet on switch then he...

nnn_sss22 by Level 1
  • 307 Views
  • 1 replies
  • 0 Helpful votes

Resolved! L3 Switch(es) VLAN

Hello! I've spent quite a while on the Internet so far trying to find whether WS-X4548-RJ45V+ Catalyst 4500 PoE+ Ready 10/100/1000, 48-Port (RJ45) switch supports VLAN and how many trunk ports it has. However, no matter where I've looked so far, it o...

Dear all, after i show log on my switch i saw the error as below: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0000.xxx in vlan xx  is flapping between port Po1 and port Fa0/1 How can i fix this error? what's wrong? Best Regards,

Hi, vlan A and vlan b (wired) the mac device from the  vlan a cannot access vlan b , To get it done I should do the following on my distribution  interface Vlan100 ip address 10.10.10.1ip pim sparse-mode!interface Vlan20010.10.201ip pim sparse-mode!...

hi, i got a nexus 5k switch and would like to add a local admin. i would like the password to be encrypted but doesn't let me. can someone advise how to do it? the password is accepted if i didn't type 5 before it. N5K(config)# username admin pass ?...

looking into how I might utilize private vlans on a 4500- sup6le ver 15.2(2)E3. Seems pretty straight forward. The documentation outlines how to create a community vlan, however, I have no option to create a commuinty. Using vlan 104 as a primary I h...

Over the years, our company has had several contracting firms implement various portions of our corporate network. Each time there has been no consistency in regards to following best practices, and now several problems are surfacing as a result.  Ou...

Because of administrative distance will a static default route replace an external EIGRP advertised route?  We are getting an advertised external EIGRP route coming in from our ISP's edge router located in our building, what I'm asking is, can we ent...

sgalarza by Level 1
  • 506 Views
  • 8 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card