Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have a NIC teaming setup. 2 NIC cards, NIC-1 connected to SW-1, NIC-2 connected to SW-2.SW-1 & SW-2 are up-linked together(not stack). The NIC ports are hard coded as access, spanning-tree port-fast.Teaming works fine under normal conditions.When I...

avilt by Level 3
  • 618 Views
  • 3 replies
  • 0 Helpful votes

Hi, I want to upgarde a Cisco Catalyst 3750G 24T because I can't see the web interface.I checked the documentation and see a lot of videos on the net.I downloaded the new firmware c3750-ipbasek9-mz.122-55.SE9.binI downloaded a tftp software and putte...

All switches are 3750x and in different buildings. Users connected to Switch 3 cannot ping servers on Switch 2 that is connected directly with fibre, when Switch 2 looses connectivity with Switch 1. Switch 1 is connected directly to switch 2 with fib...

Hello all, we have a SPA-IPSEC-2G module installed in a 6509 with sup720, and 7600-SSC-400, running s72033-advipservicesk9_wan-mz.122-18.SXF17a. Currently we are using and encrypting traffic on 1 giga interface, but in the near feature we will add a ...

Resolved! Vpn backup link

Hi, can you help me with any article to teach me to configure a vpn tunnel over the Internet as a backup link.Currently I have a mpls link as a primary running eigrp protocol. Thank you very much

We are replacing our managed switch and need to log in to see how they are setup.  One problem is that they were setup 5 years ago by an integration company that has gone out of business.  I was wondering if Cisco has a overriding username and passwo...

 We're running a couple of Cisco Catalyst 4500-X (SUP7) and using the 3.4 version. I was looking for a upgrade and saw that there was two "new" versions ready for download. I haven't read the release notes yet, so i'm just asking kindly for experienc...

jhalldn by Level 1
  • 815 Views
  • 3 replies
  • 0 Helpful votes

Guys,I'm trying to find sample log output for Power Supply failure.  My goal here is to write an EEM or ESM script to forward a log when a power supply failure is detected.  This log will trigger an email notification by our syslog server to notify m...

Hi,on a ISR platform with HWIC-4ESW or EHWIC-4ESG (4 fast ethernet switched ports),- with interface fa0/1/0 toward customer #1 using vlanid 100, 101, 102, and 1(native),- with interface fa0/1/1 toward customer #2 using vlanid 201, 202, 203, and 1(nat...

pascalfr0 by Level 1
  • 543 Views
  • 2 replies
  • 0 Helpful votes

Hi Gurus, Below are the three VLAN's I have created on my First Switch for the first time ion my lift after watching couple of videos.I am connected to the switch using a serial to usb cable via console. sw1#show vlanVLAN Name                        ...