Switching

I am working on a config to help with VOIP issues and some expansion for my company.we have a COX Optical 25 meg fiber line coming in to their equpment.its patched via Cat6 which is plugged in to a 8 port netgear gigabit switchwith 2 connections goin...

                   I have to convert single mode input into multimode using 3750-E switch to support upto 300 mbps of throughput.The other ends are 7600 and a tipping point ips. From 7600 i have single mode fiber coming and i have to connect switch t...

I set up IP SLA for icmp-echo on an IP that would then be tracked by a static route. The IP SLA summary showed this as succeeding but the route is not in the routing table.  I believe this should be all relevant configuration and output. The IPs and ...

Hi there, I just got my Cisco 3524xl-pwr 24 ports switch. I was wondering how do I access the setting from the browsers? I've tried, I clicked on Cluster Management. I got an error saying 404 can't find /home.htm or something like that.Can someone pl...

i have a WS-C2960-24TC-L with IOS c2960-lanbasek9-mz.150-2.SE4 or IOS c2960-lanbasek9-mz.122-55.SE7when switch running on dual power RPS+internal#sh env allFAN is OKSYSTEM TEMPERATURE is OKPOWER is OKRPS is AVAILABLEwhen i unplug the RPS cord#sh env ...

Hi,I would put a ACL on a 6500 (WS-C6509 Software, Version NmpSW: 7.4(3)) on Catos. On IOS here the ACL :access-list 23 access-list 23 deny host xxx.xxx.xxx.xxxaccess-list 23 permit anyint gigax/xip access-group 23 outBut on Catos I don't understand ...

Is it possible to have both tacacs+ and local login running on the Nexus Platform, without the tacacs+ failing to reach the server and local login then accepted? We are managing devices for a client and they are using tacacs+ authentication but we ne...

Hi, I have cisco switches, router and firewall trying to sync time with AIX NTP servers. All of them are not successful. AIX server (172.16.1.41) is stratum 2, it sync its time with Windows NTP server (172.16.1.51)I understand that cisco can't sync w...

Hello all, Basically I am trying to use Wireshark to do a packet capture on a Nexus 5010. I want to do a monitor session on on the switch so I can capture from a source port to a destination port on the same switch. I can configure the source port bu...

  we have been troubleshooting slow performance on our n7k for almost 2 months with cisco tac and netapp. the case hasd been elevated to level 1 and we are no closer to an answer on why using certain applications like netapp snap mirroring runs much ...

Wondering if there are any real worlde issues with stacking a pair of 4500X?Data sheet says: 4500x Number of stackable switches in VSS Up to 2Standard Stackwise cable ok? Any config or install issues? thanks

Hello All, We have the following setup C1 and C2 are Core Routers peering with same ISP through ebgp and ospf peering with D1 and E1. There is no firewall between C's and E but there is active/passive setup between C's and D. Now, let's assume D1 is ...

My slave supervisor engine WS-X4516 has failed, remaining active supervisor engine is of the same model. i would like to replace the WS-X4516 with WS-X4516-10GE, below are questions i'm facing.1. would this two engines work together.2. i don't know t...