Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi,I would like to prioritize flow from 192.168.X.201 to 192.168.X.215 in output on my Cisco 881:Configuration:Access-list 111 permit ip 192.168.X.200 0.0.0.7 anyAccess-list 111 permit ip 192.168.X.208 0.0.0.7 anyClass-map match-any VOIPmatch access-...

Hikindly help on access control list that is only ip with 192.168.2.6 mask 255.255.255.244 should be able to access internet and deny all(what should be done on cisco router) switch ip address is 192.168.2.2 mask 255.255.255.244 router ip address 192...

Could anyone help me with Cisco 6500 QoS configuration?I would like to divide bandwidth of an interface in ratio 70/30. CBWFQ configuration on a router is quite straightforward and simple:ip access-list enxtended ACL   permit ip 10.0.0.0 0.0.0.255 an...

This is regarding secondary static routes.As per existing setup from core switch we have two links..1. One goes to McAfee firewall and then ASA firewall( Core-->McAfee-->ASA )2. Other one dirctly goes to ASA firewall( Core--> ASA)Now , In network tra...

Hello,I have two Cisco 2950 switches and while one of them has the Express web setup available, the other does not. I just updated the switch to IOS 12.1(22) EA14 thinking maybe the version was too old and still nothing.When I run "dir flash:" it sho...

I worked in a company's online gaming service. The condition of the network from my office right now is comprised of one core router and one core switches. When no maintanance, cpu load the router to run normally, but when it happens maintanance like...

o2flamers by Level 1
  • 1210 Views
  • 2 replies
  • 0 Helpful votes

We currently use a lot of 24 port 2960G switches deployed on a fiber backbone with local client cat6 drops. I am wondering ig an option exists to disable switch ports if the fiber backbone is disabled.For example if my fiber breaks, can the switch se...

rlarson10 by Level 1
  • 887 Views
  • 5 replies
  • 0 Helpful votes

Resolved! 10G interface

Hi Expert,There are some 10G ethernet interfaces (fibre connection) will be activated for the backbone switching. Grateful if you would advise on following configuration setting: 1. Fix the speed to 10G and full deplux (not auto)2. dot 1 Q trunk with...

Hello peopleI would like to understand what the different queues do but there is no information I can find and from what I see they are fixed so maybe can do nothing about my issue which is I see drops on queue 8 and 11 asic 4 as shown below.DIST-ANG...