Switching

I have an Ethernet WAN link that terminates on a C3560G and I am looking to give some applications a higher priority or higher bandwith. Does anyone know if the 3560 can do this and what commands would accomplish this?Thanks,

Hello All,I have to configure a port for Printer VLAN on L3 switch. After configuring the port for printer VLAN, the printer IP is not pinging. Same printer is pinging if it is connected to any other switch of the same VTP domain. Troubleshooting don...

I have a couple of 3750 stacks.I am trunking them together (I am runnign BGP on each of them with seperate providers and AS numbers...)I am trying to set up some redundancy int he trunks so should one of the 3750s fail, the trunk will remain up.  I t...

Hi all !I researched on the Internet and I didn´t found the definition of a self-looped port and how it works. Any one knows ?Thanks

Hi,We have Cisco 6500 VSS deployed in two data centers and layer-2 extended between them. For the same VLAN we use different ip address in each DC. I want to know if it possible to run HSRP between the DCs.Current implementation:Vlan 20DC1 Vlan 20 SV...

Hi! We are trying to setup an IPv6 DHCP-Server on a Cisco 878 (c870-advipservicesk9-mz.124-15.T13.bin). There is another problem with the availability of the router. When you boot the router, he is broadcasting the IP-addresses but after about 30 min...

Hi, i've read http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080124c7d.shtml and it is stated"When the metric of the redistributed route from multiple ASBRs are equal as illustrated in the document, the forwarding address changes ...

Hi,I would like to know whether IOS supports NM-16ESW module and 802.1x protocol?I tried to setup a virtualized c2621 router with IOS IPBASE 12.3-6b and dot1x commands are missing.I tried out this description:http://www.cisco.com/en/US/docs/ios/12_2/...

HiI am confuse with below question.1] Spanning Tree  Port Fast will enable automatically when i am using RSTP, Whether it will treat same as Edge P2P ?2] Can we use Port Fast with STP or PVST & that port treated as P2P or Edge P2P?3] What are the fea...

Hi All,I have to enable dynamic routing protocol (pref EIGRP) on my network whcih is working with static routing now. I am attaching the Network Diagram and the details of the requirement.At each sites I have 2x6509E Core switches, 2 routers and 3 WA...

Hi,Does anyone know of a way of stopping EIGRP from converging back to a link if it is more preferable once it becomes available again?Scenario:Two sites, two links, 100Mb primary and 10Mb back up. EIGRP domain across the two sites, but the 10Mb is B...

Hi ExpertsBelow is the output of "show mac-address-table count" output from L3 Switch. PLease help me to understand meaning of all lines. I am also seeing the MAC address count available is 32768 and in Use Mac-address table is also close to 32768. W...

I have a vehicle that has a laptop computer connected to a repeater /bridge in the cars trunk. Pull up to a LWAPP hotspot the control sees the repeater as a client and says it is not authorized. I see the assigned address of the repeater as well. The...