Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have an 877 that I have configured to retreive its clock from the internal DC. It appears to get the NTP packet but is then somehow unable to apply the data. Here is the debug:187581: *Oct 30 13:48:39.286: NTP: xmit packet to 10.0.0.10:187582: *Oct...

expertI am currently trying QoS for video conferencing,And the main protocol of video conferencing is H.323, current setting on the port which end point plugged in is: (cat3750)interface FastEthernet1/0/6 description testing switchport access vlan 10...

julxu by Level 1
  • 4117 Views
  • 5 replies
  • 0 Helpful votes

I am upgrading a 3800 series router and I need to backup the flash card and install a new one in its place. What is the command to backup the card onto my computer via tftp and then what is the procedure for putting the information on the new card wh...

I am currently working on a migration project. We have two LANs running parrallal during the migration, one 192.168.1.0 and the new 10.1.1.0. Now I have a user (10.1.1.6) needs to access a server (192.168.1.7) on the other LAN. No other inter lan acc...

Attached is the simplified digram for the network being talked on. A,B...E refers to the local branches. R1...R5 are respective branch routers. layer2 Switch is the aggregation point & Aggr router is the one connected to the private cloud for interco...

suthomas1 by Level 6
  • 1204 Views
  • 7 replies
  • 0 Helpful votes

HelloI have two Vlan (Data 10 and voice 20) configured in my Catalyst switch.Ip phones are conected to the Catalyst and workstations are connected to the Ip phones , every device receive the correct Ip address .Now , I should add a new data Vlan (3...

Hi, I have a 6509E platform with redundant supervisor cards. I noticed one was in ROMMON (not sure how it got there) and when I boot it back up it had an older IOS. I copied the new IOS that's on the active card. Do I just need to reload the (col...

This command has been mentioned in one of my BSCI textbooks; and I have further googled it, and looked it up in the configuration guides here on cisco.com.It still.Doesn't.Make.Any.Bloody.Sense to me.Has anyone come across or used this command in rea...

Hello I need to know how can I configure a trunk port in switch 3750 and sw linksys SGE2010P?What need to configured over linksys to connect to sw 3750. I have vlan Voice and Data. How this work?anyone can help me?

Lennin by Level 1
  • 1691 Views
  • 1 replies
  • 0 Helpful votes

Hi,we build with two VS-S720-10G a vss cluster. (IOS 12.2.18sxi1)with the command "sh mls stat" we see the following output Statistics for Earl in Module 1/5L2 Forwarding Engine Total packets Switched : 64979858519L3 Forwarding Engine...

S.Bahl by Level 1
  • 666 Views
  • 1 replies
  • 0 Helpful votes