Switching

Anyone know how to change a catos device password , telnet or enablepass via snmp if you know the community strings. Have been unable to find anything on the website and don't want to have to go thru the manual recovery process. Any webpages I can ...

I have a switch WS-C6509-E with supervisor 720 up and running. I inserted a new WS-X6748-SFP module on an empty slot (hot insertion) and after the online diagnostic I received the following error: "%PM_SCP-SP-3-TRANSCEIVER_DUPLICATE: Transceiver in L...

Hello,complete novice here.... just established a new network to add to the mix where do I start ? thanks

I'm helping our Windows Admins configure WOL. To make it so I didn'have to worry about IP directed broadcast, I am simply trunking all the needed VLANS (like 4 or 5) to the windows box, and they will bring up a local interface on each VLAN to send t...

I am having problems getting GRE to passthrough the 2821, and have been working on the issue for days. I have gotten port 1721 forwarded, but this is hanging me up. The Config is attached.Thank you in advance for all of your help and being such a won...

Hi allon a cat 6500if I typehw-module reset, does this reload the backup supervisor? or do I need to type hw-module 6 reset ?and also, is the command, redundancy reload peer the same thing ?

Hi,I am having difficulty enabling WCCP outbound redirection on a Cat6509-E 720 10GE and a Bluecoat Proxy SG800.The 6509 is running 12.2(33)SXI1 and has the following WCCP config:ip wccp web-cache redirect-list 120int vlan XXX ip wccp web-cache red...

This was answered in a previous posting, but I am unclear on the answer,According to Cisco documentation: "Monitored Traffic Direction You can configure local SPAN sessions, RSPAN source sessions, and ERSPAN source sessions to monitor ingress traffic...

Hi allcan anyone tell me if all line cards on say a 6059-e forward all traffic locally if going from port to port ? ie does it have a cam table on the card itself, or does it need to ask the Supervisor engine ?

Hello all I just achieved my CCNA last weekend, now i'm trying to redo my home network. I currently have 2610XM router that will be routing my internet connection. I have two ethernet ports, one will be bridged from the ADSL modem, to the eth 0/1 in...

Hi:Roueters RIB shows 2 default routes learned from two OSPF neighbors.Why do I only see one LSA for th default route if two neighbors are sending LSAs?router 4#sh ip ro 0.0.0.0Routing entry for 0.0.0.0/0, supernet Known via "ospf 16586", distance 1...

Hi allby default what kind of messages will i see on the console output ? as I have seen spanning tree notifications before, is this the default ? the same with eigrp adjacancy changes etc ?

Hi Guysi have to rate limit the bandwitdh from a specific subnet going to a particular server.i plan to use MQC policing so whts u r advice this.I am confused abt some terms in rate-limiting.i understand the confrim action and exceed action not sure ...

We have clients that would like to connect non-Cisco switches to Cisco switches. I have been told that this is something that Cisco TAC will support, and is fully supported, so far as the non-Cisco switch supports the sameindustry standards that Cisc...