Switching

Hi all,Here I attach the diagram that demonstrates my setup in which Cat6500 Supervisor Engine, Internet Router and provider Edge Router are in vlan-2. All devices making OSPF neighbor relationship to each other and both routers are directly connecte...

The following results occured during an online diagnostic test.Switch 1: SerialNo : CAT0806Y189 Overall diagnostic result: MAJOR ERROR Test results: (. = Pass, F = Fail, U = Untested) 1) TestPortAsicStackPortLoopback ---> . 2) TestPortAsicL...

hello!I need to reconfigure DMZ (several external servers) on ISR2811.I kindly request for design scenarios, configuration guides for DMZ (best with ISA server in LAN) on cisco.com or other.thanks in advance.

Please I need this information for this Switch, ill be very thankfull!!1Also:1) Which private Snmp MIbs are for this Switch implemented?2)Are these Private Mibs in the Storage medium to find?3) Which of the following static Funktion those thhis Switc...

I'm having an odd issue. I'm running 6509's using Sup 1's running 6.3(3) CatOS with MSFC-1's using IOS ver 12.1(2)E. Yes it's old.Every now and then Windows XP workstations, both DHCP and statically assigned, detects a duplicate IP. I searched for a ...

Hi All, pls let me know about the flash file used in 2821 router . i have attached flash document . in these doc there are lot of file pls sugest that which file is unnecessary and also use of files.Thanks in adavance

I have a three switch stack consisting of2 3750G-24s1 3750G-48pI am trying to connect a 3750 via the gigabit fiber port to a 7206 NPE-400 Sup Engine gigabit port.The 3750 is using the 1000base-SX SFPThe 7207 is using the 1000base-SX GBICAfter experim...

Hi,I got this message after i reload it "!!! WARNING: The switch is not usable !!!", i made a IOS UPDATE before the "reload", when i tried to roll back the IOS the switch doesn't works, the same message was displayed.See attached the Switch initializ...

HelloI have some Catalyst 3560's that has about 10 VLANs setup on them. I want to isolate a few VLAN's from being able to access certain VLAN's but only in one direction. For example: Vlan 100 is 10.10.100.0/24Vlan 200 is 192.168.100.0/24I would li...

Hi,On which type of interfaces HSRP can be enabled on L3 switches. I beleive it can be enabled on SVI, Routed port only. Can it be configured on port-channel interface - if yes how ?Please share the experience?Any link on Cisco.com?Thanks in advanceS...

I'm trying to apply an ACL to an access-layer interface on a Catalyst 4500 running 12.2(50)SGThe ACL looks emphatic to me ... but in fact, it has no effect on traffic -- the end-station attached to this interface is unaffected and can ping, query DNS...

I advertise the following subnet into eigrp 172.16.115.0/24. I have a situation where I want traffic to a couple of servers within this subnet to follow a different path. If I add more specific static routes to these servers and redistribute these st...