Switching

So in windows if i have a telent session open to a router/switch after a while it will timeout. Typically if that command prompt has been open for several hours, when i come back to it i cannot exit or close the window. Going into task manager and ...

Hi Guys n Gals,I am having an issue with applying a route-map to an SVI to route certain traffic via a redundant link.The route-map is configured as follows,access-list 101 permit ip host 10.2.10.14 host 10.1.10.10 access-list 101 permit ip host 10.2...

Hi.I have tunnel between 2 office, network services are working well. When I open the internet site, it does not work.My config:R1. crypto isakmp policy 100 authentication pre-share ! crypto isakmp key 123 address 10.10.255.2 ! crypto ipsec transfo...

Hi all. I have a confusion regarding transparent bridging over a serial link. My diagram is simple R1 is connected to R2 via serial linkR2 is connected to R3 via Ethernet link.On R1 Serial i have given IP 10.0.0.1/8On R3 Ethernet i have IP 10.0.0.2/8...

When the router loads, i getrouter(boot)any ideas?

Dear All,I have a core switch Cisco 3560G and configured vlans on it 2-11..Linksys switches are connected with Vlans and users are connected via linksys switches,I applied an ACL in the Router to give Internet access to only selected users, other use...

hello sir,i have catalyst switch 4507R and i want to knoaw about the switch have supervisormodule and have two console Port. this is for wich requrement.

Hi,I have below networkR1 ------ R2 (Fa0/1) -- (172.30.22.1/24)The network connected to interface (Fa0/1) on Router2 was down; therefore R2 triggered partial update about this network as poison to R1.My question is why R1 is advertised the poison rev...

What is the best way to find out the current stable IOS version? Every time I read something on the subject it always seems to add a conflicting view point. Thank You

Picking up Undersize errors on 3750 12.2.37 ports connected to Nortel phones. Counters increment periodically. Not sure if this is a cosmetic errors or the Nortel phone really sending out short packets or possibly sending out untagged packets on the...

Hi,I met a problem when using 802.1q tunneling with layer2 protocol tunneling enabled(I am tunneling RPVST packet). there is physical loop structure in my network but RPVST should break it logically, right? Have you guys met similar situation? any re...

I got 02 x 4507R chassis. I want to perform IOS upgrade. It is in SSO mode. The config-register is 0x2101.From this URL, http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst4500/12.2/37sg/configuration/guides/issu.html#wp1091552, under Prere...