Switching

Hello,I'm looking for a way to monitor our switches for how much power is being used. I know there is a "show power inline" command, and I've used that many time but I'm looking for a way to monitor it with SNMP. Has anyone found an OID that gives ...

Hi, I have configured the Qos on my Core switch (C3750E Software (C3750E-UNIVERSALK9-M), Version 12.2(44)SE1) and I have notified that when MLS QOS is activate on the Core then it's not possible to match EF DSCP packet on my input policyp-map located...

I have a WS3750G switch with a Gigabitinterface configured to speed 100Mb. How do I decrease this speed to only 20Mb (logical). I can't find any suitable solution for this.The reason for this is that the providers Foundry switch discards packets if m...

I have the following extructure.Router A (3825) connected to a fiber 200 MB (Gigabit Ethernet 0 / 0) with the ISP, a router B (3825) which connects (Gigabit Ethernet 0 / 0) to the router via radio. The router B has a gigabit Ethernet (0 / 1)with 12 ...

HiIs it possible to configure Layer 3 Etherchannels on a 6509 (hybrid mode).Thanks in advance.

According to technical references, the Next Hop field in the EIGRP IP Internal and External Routes TLVs identifies the next-hop router to send packets destined for a destination network. I have performed some POC regarding the Next Hop field but it...

Hi, I have configured static routes between two routers. I have 4 links between the routers & have traffic routed. The interface IP address :Router -1:Serial 0/0/0 - 192.168.248.1 255.255.255.252Serial0/1/0 - 192.168.248.5 255.255.255.252Serial0/2/0:...

Hello,does anybody know if it's possible to configure a lacp channel between a server blade in a p-class chassis and the both cgesm switches so that nic1 connects to switch1 and nic2 to switch2?In other words a lacp channel where each of the physical...

hello, I have a catalyst 4506 that moniter vlan servers and vlans users, eatch vlan is represented with a vlan interface, i want that traffic to servers pass over an IPs, how can i do that? and how can i connect my ips to the catalyst 4506 ? thank

Hi,I'm experimenting with an 1812 router and have had to return it to factory settings after getting myself into a fix. I can now only access the router via the console port but no longer by the Security Device Manager. I assume this is because retur...

There are 2 vlans in my switch, the input rate of vlan1 is 13Mb/sec and the output rate of vlan10 is 12Mb/sec. There is no flow in any other port both input and output. The servers whitch connected to the switch run well. Why would be this ?There are...

I have been running into a problem lately with VM Virtual servers dropping packets or slow response times. No errors are showing on the switchport VM is connected to. I am thinking it might be a problem on the VM side, but I am not totally sure. A...

I ordered 18 WS-C3750G-24TS-1U's and noticed that the covers for the DC input are no longer included. Also that the bracket and four screws are now in one single bag. Is this to be expected?Also, how do I register my new product?