Switching

Hi all, I have two CE500 switches connected through 100mb ethernet PoE (smartport role set to switch) to 350 series bridges on both sides. Twice this week the remote side bridge has lost power and both sides disabled the trunk ports "due to one-way t...

Hello, I can't find the feature, so I want to know if the 6500 (IOS based)could be a DNS server ?. Can somebody provide me some information about ?Thanks a lot. Regards, Anacelia

Hello All,I have XP clients with Gigabit Ethernet cards on them.After they use their ADSL connection at home they are coming to office somehow that clients could not get an IP address from my network till I make ipconfig release renew.Even I restarte...

Our ISP has provided us with a public IP. I have connected their Modem of a Cisco router 1710, and the second port (FastEthernet) to our internal network.I have Natted the public IP to one of the PCs inside our network, so that the outside world can ...

I shut down my 3640 router which i use for RAS access and now when i power it up it goes into ROMMON mode,any suggestions on how to get it back to it's normal operating mode without losing the configs on the box..?

Imagine you need to provide Cisco switches for manufacturing equipment (i.e., robots). This is a mission critical environment.Instead of placing (2) stacked Cisco 3750 48 port switches (with RPS 2300) I would put (2) 3750 24 port switches. That way I...

hellocan anybody help me to understand the advantages of cat4948 compared to a 3560E.thanks

Hi all, to configure a username on routers, do I just typeconfigusername xxxx password xxxxor do I need to do aaa new model first ?

Hi all, Can anyone tell me how many channels my router is using by this config?pri-group timeslots 1-8,16thanks

I'm in the process of deploying c3750-24FS switches for workstation access. They are running adventerprise 122-40SE IOS. On a very random basis ports will lockout and will only allow the client access if the switch is reloaded. It's only happening to...

Hi,I have a topology of Router-->PIXFW-->CoreSW; the setup I have is as follows:- The router is configured as router-in-stick where f0/0 is holding VLANs 101,102- The PIX is configured in multiple-context mode where context1 outside holds VLAN 101 an...

When configuring vty lines on a router is it mandatory to use the login command or can we use the telnet connection with just configuring the password alone w/o the login command?

So, an error message thet it displays in console:00:43:27: %SYS-2-CHUNKINVALIDHDR: Invalid chunk header type 31744 for chunk 0, data 2C032000-Process= "HULC multifs process", ipl= 0, pid= 38-Traceback= BA03E0 1038F50 579598 57A6E8 57B84C 511378 5116F...