Switching

Hi All,Is there any approach that can let me know the date of manufacture or sale of the router by using its s/n?Hope for your kindly help!!Jason

how to create the access list in the cisco 2811 and how to activate the acl

Hello,Can someone please direct me where i can find documenation on troubleshooting SPAN/RSPAN problems.Thanks.

HiWhat router would you recommend for the following setup/change1 existing network that must be split into 4 new subnets Routers must be configured with static routes with 1 smart router (5 routers in total)Uplink: 1Gig fibre optic cable with LX conn...

In a hotel IPTV environment we have video servers and setop boxes as streaming clients. The network is build with catalyst 4506 (central switch) and catalyst 3560 (edge switches). All components are igmpv2 speaker, on the switches is igmp snooping en...

I've got a 1721 router which I'd like to get to the rommon prompt. My question is how do I do that from the enable prompt. I have windows XP system and HP platform. But Ctrl-Pause sequense key do not work. What sequense is good with my platform. Than...

I have an 6513 switch with sup720-3B module and i am finding difficulties in creating VLAN in the switch, its allowing me to create but once i exit of the configuration it gives an error message and the error message is like " Error exiting config-vl...

Hello I need little help, becouse I don t understand when I configure port security on switch, do I need to use switchport mode access and then switchport port-security something or I can use just 2 line,when I should use first line thx

I must be having a brain sludge day.Senario2 x 3570's (stackmembers) at location A2 x 3570's (stackmembers) at location Bthey are connected via 2 trunks in a etherchannel group.The question is for command snmp [authentication |coldstart | linkdown |l...

This is a weird one. I have three switches:1. Catalyst 2950 (100 meg with 1000Base-SX uplinks)2. Catalyst 500 (100 meg with 1000Base-SX SFPs)3. Catalyst 500 (gigabit)Switches 1 & 2 are uplinked via 1000Base-SX, switches 2 & 3 are uplinked via 1000Bas...

On a Cisco switch is the command :-copy running-config startup-configavailable, as on a router ?I recall reading that on changing the running config on a 2950 or 1900 Catalyst switch, it is written immediately to NVRAM, so the above command is NOT av...

I configured "router on a stick" and NAT on a 2621 router using a DSL connection for Internet access. My hardware equipment and configurations are attached.Host A or B can ping their own gateways and each other's gateways. However, host A cannot ping...