Switching

I want to make the balancing of outbound of two ISPs. I made the following configurations, but he did not function. somebody can help me?int s0: ISP-1int s1: ISP-2eth0 10.10.10.1/24mail server 10.10.0.2proxy/ftp server 10.10.0.3---------------------B...

Hi,I have a few Cisco 6509s with Febric Enabled cards. I would like to enable NSF-SSO redundancy between the Sup720 but the document says following."With a Supervisor Engine 720 and Release 12.2(18)SXE and later releases, if all the installedswitchin...

Hi all, when making redudant routers, is using hsrp more used for defaukt gateways, as on a wan link using a routing protocol would achieve the same thing !

I want to know the stabality of 12.2(18)SXD7b version for a 6513 with Sup2 module.

I have just purchased a 2811 rtr with an nm-cem-4te1 module and it seems that it does not come up during the boot proccess?I loos like the it on the 2811 that 1 is the slot number?thanks for your help

HiFor me to be able to configure QoS, VoIP, telephony, do I need the ipbase or enterprise version of the images?This is a Cat4510?Thanks

Dear Friends,I need exactly the CLI based commands to configure the following scenario:I have Four Catalyst 2955 Switches with Enhanced Image software and all four switches are connected in Mesh Topology and Running RSTP (Rapid Spanning Tree Protocol...

Hi all, can anyone tell me why creating an access list allowing an ip subnet to another one through my firewall would not let me connect remotely to the pc, until I added the tcp port of the program in, I thought ip would of covered this ?cheers

My boot varaible on my 6509 is as under:BOOT variable = bootflash:cat6000-sup2k8.8-6-1.bin,1;bootflash:,1;CONFIG_FILE variable = slot0:switch.cfgConfiguration register is 0x10fignore-config: disabledauto-config: non-recurring, overwrite, sync disable...

Hi All,I would like to do sniffing on a switch where the server connected to check the traffics to the server. How can I achieve using Ethereal and the configuration on the switch?Thanks!

Hi,I realize there is AutoQos for Voice. Will there be guidelines and future features to implement AutoQos for Video. I was reading the white paper on AutoQos and it mentioned that the features of AutoQos would be extended to include Video-over-IP...

I am installing a new image onto a Cat4510R and on it I can see confreg: 0x2101 instead of the normal 0x2102. Why is this and should I change it before I continue to download and reload?Thanks

Hi!We have 3 switches connected with each other and formed a ring topology.When i try to make l2 point-to-point tunnel , one of my edge switch (where i try to up dot1q trunk and udld port) can view another one ( udld protocol up for few second and cd...