cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
702
Views
15
Helpful
4
Replies
azi123
Beginner

Bridge-group

Hi every one,

 I have cisco 2960g (2960g-24TC-) which runs IOS 12.2(55)SE-BASE-CRYPTO. I have a problem to define multiple Bridging groups. The CLI shows that the " host_name (config)#interface BVI" is a available command, but no way of defining new BVI by interface number. The screenshot shows this problem.

Could you please help me with this problem?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Georg Pauwen
VIP Expert

Hello,

 

as far as I recall, bridging (IRB) is not supported on the 2960.

View solution in original post

4 REPLIES 4
Georg Pauwen
VIP Expert

Hello,

 

as far as I recall, bridging (IRB) is not supported on the 2960.

View solution in original post

Julio E. Moisa
VIP Mentor

As Georg mentioned it is not support on this model.

Basically Bridge groups can be created on Layer 3 devices like routers or firewall and probably on some robust multilayer switches.

 

:-)




>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

Hello

Was just wondering thiis switch although it’s really only a L2 switch it  does have limited routing capability but you need to be using the correct SDM template that that capability  - 

show sdm prefer 

 

However if the other guys have already checked that IRB isn’t applicable then changing the switch to the above template would make no difference.

 

 

 

 



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

They can also be created on Access Points which are layer 2 devices. :)