09-15-2018 11:59 PM - edited 03-08-2019 04:10 PM
Hi every one,
I have cisco 2960g (2960g-24TC-) which runs IOS 12.2(55)SE-BASE-CRYPTO. I have a problem to define multiple Bridging groups. The CLI shows that the " host_name (config)#interface BVI" is a available command, but no way of defining new BVI by interface number. The screenshot shows this problem.
Could you please help me with this problem?
Solved! Go to Solution.
09-16-2018 12:54 AM
Hello,
as far as I recall, bridging (IRB) is not supported on the 2960.
09-16-2018 12:54 AM
Hello,
as far as I recall, bridging (IRB) is not supported on the 2960.
09-16-2018 06:13 AM
As Georg mentioned it is not support on this model.
Basically Bridge groups can be created on Layer 3 devices like routers or firewall and probably on some robust multilayer switches.
:-)
09-16-2018 06:43 AM - edited 09-16-2018 06:46 AM
Hello
Was just wondering thiis switch although it’s really only a L2 switch it does have limited routing capability but you need to be using the correct SDM template that that capability -
show sdm prefer
However if the other guys have already checked that IRB isn’t applicable then changing the switch to the above template would make no difference.
02-13-2020 07:21 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide