12-14-2012 11:14 AM - edited 03-07-2019 10:36 AM
Hi,
Appreciate if anyone can assist on this. This is a 2811 rotuer running
Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(24)T3, RELEASE SOFTWARE (fc2)
Not sure why this isn't working.
Can see it expects to parse the command. Can see this device is vtp server. Can see other vlans were defined here.
Router(config)#vlan ?
accounting VLAN accounting configuration
ifdescr VLAN subinterface ifDescr
Router(config)#vlan 35
^
% Invalid input detected at '^' marker.
Router#sh vtp status
VTP Version : 2
Configuration Revision : 1
Maximum VLANs supported locally : 36
Number of existing VLANs : 8
VTP Operating Mode : Server
VTP Domain Name :
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x20 0x67 0x65 0xB2 0xB9 0x4D 0x85 0xD5
Router#sh vlan-sw br
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active
10 Servers active
50 WorkStations active
101 IP_Phones active
1002 fddi-default act/unsup
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
Solved! Go to Solution.
12-14-2012 11:22 AM
Hi,
have you tried using vlan database ?
enable
vlan database
vlan 10
apply
exit
sh vlan-sw br
Regards.
Alain
Don't forget to rate helpful posts.
12-14-2012 12:35 PM
Hi,
vlan database is a privileged command not a global config command
Regards.
Alain
Don't forget to rate helpful posts.
12-14-2012 11:22 AM
Hi,
have you tried using vlan database ?
enable
vlan database
vlan 10
apply
exit
sh vlan-sw br
Regards.
Alain
Don't forget to rate helpful posts.
12-14-2012 12:28 PM
Thanks again for the suggestion.
Didn’t work. Neither method works.
Guess it’s time to call TAC.
Router#conf t
Router(config)#vlan database
^
% Invalid input detected at '^' marker.
Router(config)#vlan 35
^
% Invalid input detected at '^' marker.
12-14-2012 12:35 PM
Hi,
vlan database is a privileged command not a global config command
Regards.
Alain
Don't forget to rate helpful posts.
12-14-2012 12:45 PM
Thanks much. It's been a long time since I've used that command.
12-14-2012 11:26 AM
Hi
as suggested u need to vlan databasecommandn thn create the vlans
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide