cisco 3750x stack power between two stacks

[sergeymolchanov]

Hello.

I want to deploy a shared Stack Power between two independent Cisco 3750x swith stacks (see the topology in attachment)

Is this topology correct? Or Stack Power may be implemented only for each stack separately?

[Mark Malone · Accepted solution]

Hi

that's not recommended by Cisco so I would avoid doing it if possible

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/white_paper_c11-578931.html

"The power stack reports all of the Cisco StackPower information to the stack master; therefore, configuring a power stack that spans multiple data stacks is not recommended (see the “Best Practices” section)."