cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5947
Views
5
Helpful
8
Replies

Command to view flexstack module in 2960S?

snyggsomfan
Level 1
Level 1

Hi,

Is there any command that shows if a 2960S switch has the flexstack module installed or not? Thanks in advance!

/K

8 Replies 8

dhalevi
Level 1
Level 1

have you tried "show inventory" ?

Yes, I have tried both "show inventory" and "show inventory raw" on switches I know have and don't have the stacking module but I don't see any differences in the output.

/K

Bump

I am lookin for this as well.

show version

show inventory

show platform

show switch stack-ports

they all give the same output with or without a Flexstack module in the switch.

Try this:

"show version"

"show hardware"

Martin Cristian
Level 1
Level 1

try

sh platform status

Merci - thank you - this works.


with stack module:
C2960S_TEST#sh platform status
Status: Normal
FlexStack Module Status: Normal
C2960S_TEST#


without stack module:
C2960S_TEST#sh platform status
Status: Normal
C2960S_TEST#

 

You can also this command "show switch detail"

Switch/Stack Mac Address : 10bd.18d1.1980
                                           H/W   Current
Switch#  Role   Mac Address     Priority Version  State 
----------------------------------------------------------
*1       Master 10bd.18d1.1980     14     1       Ready               
 2       Member 10bd.1876.4a00     1      1       Ready               

 

         Stack Port Status             Neighbors     
Switch#  Port 1     Port 2           Port 1   Port 2 
--------------------------------------------------------
  1        Ok         Ok                2        2 
  2        Ok         Ok                1        1 

Review Cisco Networking for a $25 gift card