%DC-3-OUI_INIT_FAIL: OUI Table initialization failed on Cat2960X

[mhiyoshi]

Hello all 

when Cat2960X reload then it shows the following fail log is that any impact ?

H/W :  WS-C2960X-24TS-L

S/W : 15.0(2a)EX5

Cat2960X#reload
Proceed with reload? [confirm]

Aug 18 09:06:56.284: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload command.

*omit

Press RETURN to get started!

*Mar 1 00:00:54.634: Read env variable - LICENSE_BOOT_LEVEL =
Mar 30 01:27:38.150: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c2960x_lanbase Next reboot level = lanbase and License = lanbase
Aug 18 09:11:55.933: Flexstack module is 1
Aug 18 09:12:53.625: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack
Aug 18 09:12:55.160: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
Aug 18 09:12:55.160: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to down
Aug 18 09:12:56.764: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
Aug 18 09:12:57.107: %DC-3-MAX_OUI_EXCEEDED: total OUI found=%d exceeds the max supported=%d .
Aug 18 09:12:57.107: %DC-3-OUI_INIT_FAIL: OUI Table initialization failed for flash:/dc_profile_dir/dc_default_profiles.txt

[Furose M · Accepted solution]

did you do a IOS downgrade from 15.2 to this version? these files are copied when doing upgrade to 15.2 using tar image. if you downgrade without using the tar image, this message would be displayed. this wont have any impact and  u should do TAR upgrade/downgrade to take care of this.

[mhiyoshi]

Hello Yes I have done to downgrade from 15.2 to 15.0 version without archive command

but just simply downgrade to do copy tftp: flash: 

Well I have just confirmed above downgrade with archive command after that

it does not show such fail message

Thank you very much for your great and precious support.

Best Regards,

Masanobu Hiyoshi