10-16-2014 07:56 PM - edited 03-07-2019 09:09 PM
Hi ,
We have configured Dual-Active Detection with Fast-Hello but still we are seeing dual-active recovery mode: No
Please suggest
6509#sh switch virtual dual-active summ
Pagp dual-active detection enabled: Yes
Fast-hello dual-active detection enabled: Yes
No interfaces excluded from shutdown in recovery mode
In dual-active recovery mode: No
6509#sh switch virtual dual-active fast-hello
Fast-hello dual-active detection enabled: Yes
Fast-hello dual-active interfaces:
Port Local State Peer Port Remote State
---------------------------------------------------
Gi1/1/18 Link up Gi2/1/18 Link up
Solved! Go to Solution.
10-17-2014 03:29 AM
Hi,
it's not issue, so it should be actually, everything is OK...
You see - In dual-active recovery mode: No because your VSS system is running in normal mode/phase and there are No dual-active condition...
Once the detection technique identifies the dual-active condition, the recovery phase begins and you can see - In dual-active recovery mode: Yes
10-17-2014 03:29 AM
Hi,
it's not issue, so it should be actually, everything is OK...
You see - In dual-active recovery mode: No because your VSS system is running in normal mode/phase and there are No dual-active condition...
Once the detection technique identifies the dual-active condition, the recovery phase begins and you can see - In dual-active recovery mode: Yes
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide