08-30-2011 05:26 AM - edited 03-07-2019 01:58 AM
Bonjour
Je suis actuellement en formation perso sur du matériel cisco
routeur et switch achetés en occasion
routeur série 2600 ---> 2620 avec IOS C2600 software (C2600-I-M) version 12.0 (7)T release software (fc2)
Sur ce routeur j'ai le problème suivant:
Exemple
routeur#conf t
routeur(config)#int fa0/0.2
routeur(config-subif)#ip address 192.168.1.1 255.255.255.0
routeur(config-subif)#encapsulation dot1Q 20
^
% invalid input detectedat'^' marker
Est ce que ce probleme peut provenir de l'IOS?
Un routeur CISCO 2600 SERIES ROUTER - 2610 16/32MB 4X ISDN
avec IOS C2600 Software (C2600-I-M), Version 12.2 Bridging software. X.25 software, Version 3.0.0. Basic Rate ISDN software, Version 1.1
peut il résoudre ce probleme d'encapsulation
08-30-2011 05:34 AM
Hi,
you must configure encapsulation first then the ip address.
Regards.
Alain.
08-30-2011 06:10 AM
Hi
I have the same problem by configuring encapsulation first
Best regards
JG
08-30-2011 09:59 AM
i think you need adv ipserviices or enterprise level IOS to have the ability to sub-interface l3 int on a c2620 using dot1q.
08-30-2011 10:50 AM
Looks like you are running base software , you need at least IP PLUS feature set to subinterface (trunk) a link .
08-30-2011 12:02 PM
hi
is IP PLUS a download software
thanks all
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide