07-11-2013 12:56 AM - edited 03-07-2019 02:20 PM
Hi
I have 2 switch (3750) need to set redundancy, so I set up as below:
SWITCH 1
interface GigabitEthernet1/0/2
description "To EP LAN"
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 18
switchport mode trunk
interface Vlan18
description "AMS Client Subnet"
ip address 10.112.2.241 255.255.255.0
ip access-group BLOCK-PIM in
ip pim sparse-mode
standby 10 ip 10.112.2.254
standby 10 priority 110
standby 10 preempt
SWITCH 2
interface GigabitEthernet1/0/2
description "To EP LAN"
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 18
switchport mode trunk
interface Vlan18
description "AMS Client Subnet"
ip address 10.112.2.242 255.255.255.0
ip access-group BLOCK-PIM in
ip pim sparse-mode
standby 10 ip 10.112.2.254
standby 10 priority 110
standby 10 preempt
=====================
Then I think I can ping the Virtual Gateway 10.112.2.254
But I failed, tried plug in both switches, can any one help me ?
Thanks a lot
wkcalvin
07-11-2013 03:09 AM
Calvin,
Could you please tell us from were are you trying to ping the VIP IP address?
ARe you able to ping the VIP address from your Switches?
If the problem is that from the clients you are not able to ping the VIP, Kindly check if the client is on the same vlan and subnet ?
If you provide some more infomration it would be great.
HTH
Regards
Inayath.
*Plz rate all usefull posts.
07-11-2013 03:11 AM
Below is the link to troubleshoot the HSRP:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml
It may help you. Please feel free to let me know if you have any further queries on this.
REgards
Inayath
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide