Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1596
Views
0
Helpful
3
Replies

HP Virtual Connect to Cisco 3550

network_team
Level 1
Level 1

‎06-02-2008 03:04 AM - edited ‎03-05-2019 11:21 PM

Hi i paln to connect a blad to a Cisco 3550 and need to transfer the VLAN from Cisco to HP. I knwo HP do not support this can anyone give me a template to configure for the Cisco internface using the correct protocal i assum LACP?

Labels:
0 Helpful
3 Replies 3

glen.grant
VIP Alumni
VIP Alumni

‎06-02-2008 03:38 AM

If you are talking etherchannel then on the 3550 connecting ports add the command channel-group 1 mode active . This will enable a LACP etherchannel.

0 Helpful

network_team
Level 1
Level 1
In response to glen.grant

‎06-02-2008 03:45 AM

Are you able to given me a configuration example please ?

I will be configuring on SC gigabit modules

0 Helpful

network_team
Level 1
Level 1
In response to network_team

‎06-02-2008 04:48 AM

Is the current configuration below correct to transfer all vlans to a HP switch:

interface Port-channel1

description Port channel to VC1

switchport mode access

switchport nonegotiate

spanning-tree portfast

interface GigabitEthernet0/10

description VC1 Uplink, po1

switchport mode access

switchport nonegotiate

channel-group 1 mode active

channel-protocol lacp

spanning-tree portfast

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card