08-02-2019 05:43 AM - edited 08-02-2019 06:21 AM
Is the Q-BRIDGE MIB supported on the Catalyst 3650 running IOS Denali 16.3.6? I don't see it via an snmpwalk and I also don't see it on the Cisco MIB locator page.
I found this site with supported MIBs for the 3650 but I am not sure if it is 100% accurate. The Q-BRIDGE MIB is again not listed on this site. ftp://ftp.cisco.com/pub/mibs/supportlists/cat3650/cat3650-MIB-supportlist.html
If it is not supported, is it possible to load this MIB onto the switch? Thanks.
08-05-2019 01:00 AM
??? I don't think you load mibs onto a switch?
you load mibs into your management station to interpret numerical SNMP-OIDs as textual description of parameters/counters.
08-05-2019 01:11 AM
check if the info in this post answers your question?
08-05-2019 06:16 AM
This is my first experience with SNMP so I was just wondering if you could add a MIB to the SNMP agent running on the switch. Thanks for posting this link but I had reviewed this thread previously and it did not provide me with what I was looking for.
I am specifically looking to read and write these two fields:
dot1qVlanStaticEgressPorts - 1.3.6.1.2.1.17.7.1.4.3.1.2
dot1qVlanStaticUntaggedPorts - 1.3.6.1.2.1.17.7.1.4.3.1.4
I am able to do this on other vendor switches and it is a generic MIB so I am a little surprised that it does not seem supported on IOS XE 16.
08-05-2019 06:42 AM
Hello Tyler,
you cannot add a MIB to network device, MIB files are intended to be used to add in NME servers.
Either the device supports the MIB or not.
My guess is that a Cisco proprietary equivalent of this MIB should be supported by this device.
Hope to help
Giuseppe
08-05-2019 07:30 AM
@Giuseppe Larosa- You are 100% correct. I ended up finding the OID I needed under the CISCO-VITP-MIB
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide