06-20-2022 07:31 PM
Hi Gents,
may i ask if i configured my LACP properly in my cisco core switch?
here is my configuration screenshot below.
i have port-channel50 for my ESXi server and specifies it under vlan11 and only using mode access (not trunk) and also the 2 gig port under LACP. port 38 and 39.
when i ran the command show int port-channel 50 i can see that the state is down.
but when i ran the command show int gig for both the ports included in the LACP group i can see that there are packets coming in and received so for me the LACP worked but it is very confusing why the interface port-channel is down.
here are some additonal info for my ethernchannel
any help on this if this is normal?
thank you
Solved! Go to Solution.
06-20-2022 08:18 PM
Hi
It seems that both device did not agree on the negotiation. If you did right on the ESXi side, then, try to change from desirable to mode on.
06-21-2022 02:37 AM
06-20-2022 08:18 PM
Hi
It seems that both device did not agree on the negotiation. If you did right on the ESXi side, then, try to change from desirable to mode on.
06-20-2022 08:45 PM
i have configured NIC Teaming on the ESXi side. i will try your suggestion to change mode to on.
06-20-2022 08:53 PM
Hi Sir, update:
i have changed to mode on on both ports and i can now see that the port-channel 50 is up.
Thank you so much
06-21-2022 02:37 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide