cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
339
Views
25
Helpful
6
Replies
Highlighted
Beginner

monitoring port packets

Hello,

How we can get the information presented in this image through command line (the target switch is cisco sf302-08pp)

 

Thanks in advance.

 

switch.png

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Hello,

 

the CLI is limited on the SF302. Use the command:

 

show interfaces counters

 

Page 10 (Section 23) of the attached guide shows the available commands.

 

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_Nikola300_1_3_7.pdf

View solution in original post

6 REPLIES 6
Highlighted
VIP Advocate

 

 - Try show interfaces status Gigabitethernet 1 (e.g.)

 M.

Highlighted
VIP Mentor

There are SMB Switches with Limited command line access : you can refer below admin guide :

 

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_300_1_2_9.pdf

BB
*** Rate All Helpful Responses ***
Highlighted
VIP Mentor

Hello,

 

the CLI is limited on the SF302. Use the command:

 

show interfaces counters

 

Page 10 (Section 23) of the attached guide shows the available commands.

 

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_Nikola300_1_3_7.pdf

View solution in original post

Highlighted

thanks for your help,

I have another question, how can I get the data of Packets with Errors column  in Receive Statistics part.

Highlighted

Hello,

 

show interfaces counters [interface-id | detailed

Highlighted

Hello,

After running this command (show interfaces counters [interface-id | detailed ) we got the output as shown in the image below, can you tell us which attribute/s specifically represents Packets with Errors column.

Thanks in advance.

statistics_interface_counters_fa6.png

Content for Community-Ad