09-15-2020 03:36 AM
Hello,
How we can get the information presented in this image through command line (the target switch is cisco sf302-08pp)
Thanks in advance.
Solved! Go to Solution.
09-15-2020 03:50 AM
Hello,
the CLI is limited on the SF302. Use the command:
show interfaces counters
Page 10 (Section 23) of the attached guide shows the available commands.
09-15-2020 03:47 AM
- Try show interfaces status Gigabitethernet 1 (e.g.)
M.
09-15-2020 03:48 AM
There are SMB Switches with Limited command line access : you can refer below admin guide :
09-15-2020 03:50 AM
Hello,
the CLI is limited on the SF302. Use the command:
show interfaces counters
Page 10 (Section 23) of the attached guide shows the available commands.
09-15-2020 04:59 AM
thanks for your help,
I have another question, how can I get the data of Packets with Errors column in Receive Statistics part.
09-15-2020 05:40 AM
Hello,
show interfaces counters [interface-id | detailed
09-15-2020 10:59 PM
Hello,
After running this command (show interfaces counters [interface-id | detailed ) we got the output as shown in the image below, can you tell us which attribute/s specifically represents Packets with Errors column.
Thanks in advance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: