Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I am trying to get a better understanding of why something is working.  SW1 is another vendors switch which connects there devices, SW2 is my switch which connects devices on my network.  SW1 and SW2 are connected via a trunk link that allows VLAN 30...

j-mol by Community Member
  • 85 Views
  • 4 replies
  • 0 Helpful votes

The following ACL is set on the L3SW management interface.I think it is to control the outgoing communication from L3SW, but in the case of and below, I think it is possible to control the return communication only with access-group 100 in, so I thin...

CHISHIUNG by Level 1
  • 91 Views
  • 2 replies
  • 0 Helpful votes

I'm a new user of Cisco products in a public transportation agency and I'm working with both the Cisco 819 and 829 routers. These devices are installed on a large fleet of vehicles.We have written procedures for setting up both models, but the engine...

Cpt Mocha by Community Member
  • 189 Views
  • 5 replies
  • 0 Helpful votes

The following log message was output on Catalyst 9400 version 17.12.5.Is it safe to ignore this log?What does each log mean, what is the cause, and what is the recommended action? %FMFP-3-OBJ_DWNLD_TO_DP_STUCK: F0/0: fman_fp_image: AOM download to Da...

CHISHIUNG by Level 1
  • 219 Views
  • 5 replies
  • 0 Helpful votes

Greetings,I have aquired a second hand WS-C3650-8X24UQ-S. Appears to be working as is (connected to router and one pc), and no password. When looking up reset instructions, I see typically you flash_init, then delete config.text and vlan.dat (after h...

DH2025 by Level 1
  • 182 Views
  • 6 replies
  • 0 Helpful votes

I’m looking for the EU Declaration of Conformity for the CISCO1921/K9. I specifically need a separate document in the standard format. We’ve received an official request from the authorities.  Links to "cae-cnc-prd.cisco.com" are not sufficient — thi...

v-derkach by Community Member
  • 114 Views
  • 3 replies
  • 0 Helpful votes

Hello Cisco community,  I have a Cisco 9200L.  For some reason, we have had no luck migrating from password 7 to password 6.  Each time I attempt config, it gives me an error.  I even tried a new switch for additional testing, but still gives same re...

I have a Cisco IE2000 and I have a project I want to use SD Cards for config deployment.  Can anyone tell me which SD cards I can use that aren't Cisco branded?  The one 1gb SD card I tried to use gives me the normal, "Warning: Non-IT SD flash detect...

KirkM by Level 1
  • 586 Views
  • 4 replies
  • 0 Helpful votes

Hello everyone,I'm currently testing two Catalyst 9606Rs, each with two supervisor engines.In 'show module' I see the assignment as follows:Switch 1:Slot 3= Active, Slot 4= ICSActive= sso, ICS=rprSwitch 2:Slot 3= Standby, Slot 4= ICSActive= sso, ICS=...

p11l by Level 1
  • 313 Views
  • 1 replies
  • 0 Helpful votes