10-06-2008 10:44 AM - edited 03-06-2019 01:47 AM
I am trying normal password recovery for (cisco routers) for IAD 2400 but iam unable to get in rommon mode ? Help please.
10-06-2008 11:01 AM
Resolved.I was plugged in to Aux port! changed it to console , now everything is ok.
10-06-2008 11:06 AM
Hi,
Following steps should work
1.Press the Break key during the first 60 seconds while the system is starting up
2.Use confreg 0x2142
3.reset
4.It will boot without the startup config
5.enable
6.copy start run
7.config t
8.enable secret
9.config-register 0x2102
10.write mem
HTH...rate if helpful..
05-28-2013 07:12 PM
Thank you Satish! Worked like a charm!
08-08-2018 08:39 AM
Is there a way to bypass or recover the password if the "Password recovery functionality is disabled"?
I don't see a battery or nvram chip that is easily removed.
Thanks.
05-07-2019 06:01 PM
I and new to routers and switches but this set of commands has helped me on every used piece if cisco equipment I have used so far. I owe you big time I will share it with the CCENT class at West Valley Occupational Center.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide