12-07-2006 05:33 AM - edited 03-05-2019 01:13 PM
Have a 2950 switch that was configured by another company. Need to change IP address. Tried resetting the switch via documentation but when pressing the mode button switch led's do not blink. Have done this on other 2950 and 2960 switches without a hitch. Any suggestions on how to reset.
12-07-2006 06:59 AM
Hi Jack,
WHY don't you just delete the running config and do "wr mem" and then reload the switch.
Ankur
12-07-2006 07:09 AM
Hi,
If you are able to login to the switch and you want to change the switch to factory defualts, do the following:
erase nvram:
reload
Let us know if you have any other question.
HTH,
-amit singh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide