storm-control

[bluesea2010]

Hi,

I have the below configuration on the switch port. On some ports,the moment I plugged any device it is going to the error state. 

some ports working normal. What could be the issue? .Or the PPS value is very low to have in a access port ? 

storm-control broadcast level pps 5
storm-control action shutdown

Thanks

[marce1000]

 - Check logs  when the port goes down and or determine if port goes down due to storm-control configurations (or not)

 M.

[balaji.bandi]

storm-control broadcast level pps 5

that is low increase and test it.

there is math calculation, may be you can find over internet

[paul driver]

Hello
Suggest to set your SC levels to a much higher rate and then monitor for a while to establish a baseline then apply your BUM levels accordingly, Otherwise you could experience issues like this if those SC levels are set to low for what could be deemed "normal" traffic

Example
int x/x
storm-control broadcast level 99.00
storm-control multicast level 99.00

sh storm-control broadcast/multicast ( so to check on the current value the port is reaching