07-29-2011 01:43 PM - edited 03-07-2019 01:28 AM
Hi:
My syslog server is not receiving any log. Locally I can see the log.
Here is my config:
logging logfile customer1 6 size 65536
logging server 10.10.10.10 6 use-vrf default
logging timestamp milliseconds
I can ping the server from the nexus.
Thanks
07-29-2011 02:07 PM
Have you read the below
http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli_rel_4_0_1a/sm_syslog.html
07-29-2011 03:24 PM
Yes I certainly did.
Thanks
07-29-2011 03:53 PM
Are you using N5500 with the L3 features? Or L2 only?
Can you post the output of the following commands:
show ip int br
show ip int br vrf management
Regards,
jerry
07-30-2011 06:25 AM
Jerry:
Yes it is L3 5596.
IP Interface Status for VRF "default"(1)
Interface IP Address Interface Status
Vlan400 10.38.107.2 protocol-up/link-up/admin-up
Vlan404 10.18.80.3 protocol-up/link-up/admin-up
Vlan408 10.29.101.2 protocol-up/link-up/admin-up
Vlan412 10.30.100.1 protocol-up/link-up/admin-up
Vlan428 10.39.76.2 protocol-up/link-up/admin-up
Ethernet1/8 172.20.21.1 protocol-up/link-up/admin-up
sh ip int br vrf management
IP Interface Status for VRF "management"(2)
Interface IP Address Interface Status
mgmt0 10.0.0.1 protocol-up/link-up/admin-up
Note: I am using default vrf and syslog server is reachable.
07-30-2011 06:40 AM
Misunderstood you before.
What facility level is configured to receive syslog message on your server? The default for NXOS 5.x software is local7.
Regards,
jerry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide