Switching

Router(config)# int vlan 650Router (config)# rate-limit output 25000000 1000000 1000000 conform-action transmit exceed-action drop Does anyone know if this command will work to rate limit traffic exiting a 3750G switchios version 12.2.50SEB3. Also do...

Can the CGS-2520-16S-8PC supply EPoE power to drive dual band (2.4 + 5 GHZ) Aironet 1252 Access Points at full capability (802.11n)?

I have about 50+ 3550 switches running several year old IOS. Now in my network I have several vlans. Vlan 1 - DataVlan 10 - VoiceVlan 100 - switch management. each switch has an IP of 10.0.0.XXX /24THis is placed on each switches int vlan100 The prob...

i notice that when i specify the interface on the ip nat inside command it will not allow the extendable keyword.  If i use the ip address then it will allow it.  am i losing any functionality with the interface specified instead of ip address and ex...

Dears My vendor recomend for my equipment Cisco Router 3945 E the IOS SL-39-DATA-K9, but I don´t if it accept this command below!Follow a exemplo:conf t     ip vrf XXXX          rd XXXX:YY          route-import XXXX:YY          route-export XXXX:YY  ...

I need some config help with the following. I realized at the last moment during an office relocation that the ISP is not providing a router to terminate the public block.  I have a Cat3560 which can handle static routes. ISP info:Routed block 24.25....

   Hi,i need support about the steps for installation of license ipbase from evaluation ipbase on 2 different stacks of 3750-X. the 2 stacks are composed of 2 3750-X with ipbase evaluation and i want to install the ipbase license bought and remove th...

hi, i am configuring a server with two intel NICS. i have coneccted each interface trough two different switches, and the intel teaming set to Switch Fault Tolerance (SFT). I have STP in the L2 network, and set BPDUGUARD and PORTFAST in the teamings ...

Hi,We are going to use CUE and CME on cisco 2900 series router.We would be using 24 port L2 POE switch as well.Our Ip phone going to be have switch port so that cable from POE goes to Phone and from from Phone to desktop.Means vlan should sense the d...

Hello All,I'm facing to a very strange problem.I'm trying to wake-up stations from a server into a different VLAN, but through OSPF routing and multiple L3 Switches hop.Look @ the joined topology scheme. (!! BE CAREFULL !!   This is a NO PASSIVE INT...

Hello,I'm seeing an increase of Throttles and/or rx_soft_overflow_err on a Fastethernet interface.I did some research and can see alot of references of this being caused by input errors.Yet I'm not seeing any other counter increase on this interface ...

Hi Expert,I found error %ETHCNTR-3-LOOP_BACK_DETECTED: Loop-back detected on GigabitEthernet Now, i disable keepalive and error disappear but i need to know this error cause network loop or software bug?IOS:12.2(53)SE2Thanks for all reply

There are two Catalyst 6509-E switches with two Supervisor 720 modules on each of them. I need both supervisor uplinks to become VSL links, so i have configured Ten5/4 - 5 and Ten6/4 - 5 (these ports are on Supervisor modules) as VSL links, where:   ...

Hi, How can I prevent my network form virused PCs. Las night i had problems on my network and aftech checking logs in my 3560x there was problem with MAC flap.Is possible prevent network from this with config in our switches?ThanxBRDave