cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
371
Views
5
Helpful
11
Replies

Type 2 Consistency Failed

I am facing Type 2 Consistency Failed with No Type 2 Consistency reason... What are the possible reasons for this failure...?

 

Both the side VPC configuration are identical other than role priority. ?

4 ACCEPTED SOLUTIONS

Accepted Solutions
marce1000
VIP Advisor

 

       - Post exact message as seen when port(s) are configured (and include the configuration-attempt-command too)  or from the logs.

 M.

View solution in original post

balaji.bandi
VIP Master

Let us know what device and Code running these device and post output :

 

show vpc consistency-parameters vpc <vpc-num>

sh vpc consistency-parameters global

 

You need to troubleshoot :

 

https://www.cisco.com/c/en/us/td/docs/dcn/nx-os/nexus9000/101x/troubleshooting/cisco-nexus-9000-nx-os-troubleshooting-guide-101x/m-troubleshooting-vpcs.pdf

BB

***** Rate All Helpful Responses *****

How to Ask The Community for Help

View solution in original post

Both of them using VPC Ver 2.. you can check in attachment..

View solution in original post

Hello

It doesnt seem so.

NC Core-P version 2
NC-Core-S version 1



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

View solution in original post

11 REPLIES 11
marce1000
VIP Advisor

 

       - Post exact message as seen when port(s) are configured (and include the configuration-attempt-command too)  or from the logs.

 M.

View solution in original post

Can you please check the attachment.

balaji.bandi
VIP Master

Let us know what device and Code running these device and post output :

 

show vpc consistency-parameters vpc <vpc-num>

sh vpc consistency-parameters global

 

You need to troubleshoot :

 

https://www.cisco.com/c/en/us/td/docs/dcn/nx-os/nexus9000/101x/troubleshooting/cisco-nexus-9000-nx-os-troubleshooting-guide-101x/m-troubleshooting-vpcs.pdf

BB

***** Rate All Helpful Responses *****

How to Ask The Community for Help

View solution in original post

Please check the attachment...

As per the output does not seems to be an issue major, but good to fix that issue. we need to compare the config also part of this issue.

 

as per your output below command - errdisable recovery cause vpc-peerlink (only see on CORE-S not on CORE-P)

 

Like this there may be small config issue i would take in to notepad ++ and compare and start fix 1 config at a time and check.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Community for Help

paul driver
VIP Mentor

Hello
Check your vtp versions!



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

Both of them using VPC Ver 2.. you can check in attachment..

View solution in original post

Hello

It doesnt seem so.

NC Core-P version 2
NC-Core-S version 1



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

View solution in original post

Apologize for the same,, it was old attachment.... Please check the same in attachment..

Hello
Can you post the run config of both switchs please?



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

VTP Version are also same for both the nexus