Configuration to clone screens on SX20

[Waldo Roca Martin]

Hi

I appreciate a configuration that permit clone screens connected to HDMI 1 and 2 on a SX20.

Activating Dual Screens on Monitor permit use both screens independently, but I need screens shows the same on both.

I trying different combinations unsuccessfully.

thank you for the help.

Best Regards

[Jens Didriksen]

Have you tried setting Video/Monitors to "Single" ?

/jens

Please rate replies and mark question(s) as "answered" if applicable.

[Waldo Roca Martin]

Hi

Yes, I set Monitors to Single and use HDMI1 and HDMI2 on first both or first/second but second screen on HDMI 2 doesn't show anything.

If I set monitor to Dual, it doesn't  care if I set HDMI1 and HDMI2 to first o Second, HDMI 2 is always as second screen, not clone.

Thank you

Best Regards

[Patrick Sparkman]

I just tested with a C20, and was able to duplicate the HDMI outputs by setting.

Configuration Video Monitors: Single
Configuration Video HDMI1/HDMI2 MonitorRole: First

The OSD will not be duplicated, it will only show on one screen only always.

As I just tested, it should work, but there was another post a few months back someone else suggested to use the following, and they reported back that it worked for them.

Configuration Video Monitors: Auto
Configuration Video Output HDMI1/HDMI2 MonitorRole: Second

[Waldo Roca Martin]

Thank you for the answer.

I will check.

Best regards